CAMTECH LITE & PRO
Pan/Tilt/Zoom Camera Tester Setup

For Basic Operations Follow the Steps Listed Below.

STEP 1 Define your Camera Communications Format. RS232 or IP (IP communications for Future Use)

STEP 2 Define your Communications Port.
(The software will display only valid windows
communications ports available.) NOTE:If using a Quatech 485/422 card check the hardware device manager for the assigned port.

STEP 3 Select the Manufacture or Model of your Camera.
(If your Unit is not listed contact CamTech@pacbell.net)

STEP 4 Select the Device Baud Rate.
(The baud Rates are pre-defined per factory standards)
(If adjustable baud rates are required, you can Update to CamTech Pro.)

STEP 5 Select the CONNECT button.
(Any changes to the setup requires a DISCONNECT
with the exception of Camera Serial address)
 		STEP 6 Enter the Camera Serial Address.
(Any changes to the setup requires a DISCONNECT
with the exception of Camera Serial address)		 

 

Keyboard Commands: PAN & TILT

              • Page Up Arrow = Tilt Up
              • Page Down Arrow = Tilt Down
              • Home Arrow Left = Pan Left
              • Home Arrow Right = Pan Right
   
 

ZOOM LENS

  • Zoom In = I
  • Zoom Out = O
  • Focus Near =N
  • Focus Far = F
  • Iris Open = <
  • Iris Close = C

The LED will highlight if you have any data on the RECEIVE DATA LINE. When Connected to J0308ACU devices a Response is Normal Operation

 

 

 

When using CAMTECH PRO this window will display the COMMANDS sent to your selected COM PORT.
RETURN TO TOP
      
CAMTECH HOME PAGE
SOFTWARE SOLUTIONS
  
©Copyright 2006 CamTech
 A Divison of CCTV Integration Parts
      CamTech@Pacbell.net
All of the operational buttons when highlighted using, a mouse or keyboard will send commands out the selected communications port in real time as long as they are highlighted.